Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. SKU 66910
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual must
be performed only by a qualied
technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL OPERATION
OR ELECTRIC SHOCK:
Turn the Power Switch (42) of the
Chipper Shredder to its “OFF”
position and unplug the unit from
its electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
1.
general condition of the Chipper
Shredder. Check for loose screws,
misalignment or binding of moving parts,
cracked or broken parts, damaged
electrical wiring, and any other condition
that may affect its safe operation.
2.
clean out debris inside the Hopper (1),
Main Housing (14), and Chute (67).
Then make sure to tighten the Knobs
TO CLEAN THE EXTERIOR PARTS, 3.
use only a clean cloth and mild
detergent. Do not use solvents. Do not
immerse any electrical part of the unit in
liquid.
WHEN STORING, keep the unit in a 4.
clean, dry, safe location out of reach of
children and other unauthorized persons.
5. WARNING! If the Power Cord (37)
of this Chipper Shredder is damaged,
the Cord must be replaced only by a
Blade Reversal/Removal
PERIODICALLY, inspect the two 1.
Blades (20). Using dull Blades will
cause excessive wear on the Motor
(47), and will cause jamming. Reverse
Wear heavy-duty work gloves to avoid
To reverse the Blades:
BLADE
(20)
BLADE
(20)
SCREWS
(19)
SCREWS
(19)
DISC
(21)
a. Remove the four Screws (19) that
b.
sharp edges.
Then retighten the Screws to secure the c.
Call 1-800-444-3353 for replacement
blades.
REV 10h