Filter
Top Products
Operation
Stand-Alone Operation (Sound_Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1) Set dipswitches position to Sound Active or Auto Mode.
Mode Dipswitches
Sound Active 10 = Off, 11 = Off, 12 = Off
Auto Mode 10 = Off, 11 = Off, 12 = On
2) The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode, or the unit will auto change in Auto Mode.
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound Active.
N: SOUND/AUDIO 2: SOUND/AUTO
1: SOUND/AUTO
Master-Slave Operation (Master_Sound, Master_Auto):
This mode will allow you to link up to 32 units together without controller.
1) Use standard XLR DMX cable to daisy chain your units together via the XLR connector on the
rear of the units. For longer cable runs we suggest a terminator on the last fixture.
2) Choose a unit to function as Master mode. Turn dipswitches to the Master position on the unit.
The unit must be first unit in line. Then simply chain the units together using XLR cable.
Mode Dipswitches
Master Sound 10 = Off, 11 = On, 12 = Off
Master Auto 10 = Off, 11 = On, 12 = On
3) Turn switch to the Slave position on the slave units, and they will react the same as the Master.
Mode Dipswitches
Slave 10 = On, 11 = Off, 12 = Off
OUT
IN
POWER
1: MASTER 2: SLAVE N: SLAVE
LRG-55 User Manual 11 11/14/2007/18:46