Open as PDF
Intimidator™ Scan LED 4 2009-06-04/10:14
to achieve desired
The fuse is located
Remove using a flat
DMX Channel Summary
The fixture does not use a halogen lamp as its light source. Instead, it uses a high luminosity LED,
which comes preinstalled, and does not need to be setup or replaced.
To adjust the focus, please follow the instructions
1) If operating in stand-alone mode, turn the music
down so that the unit temporarily stops any activity.
2) In DMX control mode, create a static scene with
any gobo of your choice pointed to a flat surface,
ideally at a halfway point of the fixture’s total
3) Rotate the manual focus either clockwise or counter-clockwise until the spot is defined by a hard
Disconnect the power cord before replacing a fuse and always replace it with the
same type of fuse.
With a flat head screwdriver, wedge the fuse
holder out of its housing. Remove the blown
fuse from its holder and replace with the exact
same type of fuse. Insert the fuse holder back
in its place and reconnect power.