Filter
Top Products
Intimidator™ Scan LED 1 2009-06-04/10:14
1. BEFORE YOU BEGIN
What is included
1 x Intimidator™ Scan LED
1 x Power Cord
1 x Warranty Card
1 x User manual
Unpacking Instructions
Immediately upon receiving the fixture, carefully unpack the carton, check the contents to ensure that
all parts are present and that have arrived in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that the fixture
must be returned to the factory, it must be returned in the original factory box and packing.
Symbols
This paragraph contains critical installation, configuration or operation information. Failure to comply
with this information may render the system partially or completely inoperative, cause damage to the
system or cause harm to the operator/user/technician
This paragraph contains important installation or configuration information. Failure to comply with this
information may prevent the system from functioning correctly.
This paragraph reminds you of useful, although not critical, information.
AC Power
This fixture has an auto-switching power supply that can accommodate a wide range of input voltages
(100 V - 240 VAC, 50/60 Hz). Before powering on the unit, make sure the line voltage to which you
are connecting it is within the range of accepted voltages.
Always connect the fixture to a switched circuit. Never connect the fixture to a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used only as a 0% to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its
average current draw under normal conditions.
Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
Check the fixture or device carefully to make sure that if a voltage selection switch exists, it is set to
the correct line voltage you will use.
Always connect the fixture to a circuit with a suitable electrical ground.