Filter
Top Products
8
HANGING THE FAN
Step 8a. To hang the fan body in the canopy, hold the fan
body firmly and insert the ball into the canopy opening.
Check that no wires are pinched. Rotate the fan body until
the slot in the ball fits into the pin opposite the canopy
opening.
Step 8b. Trim excess motor wires, leaving at least 6 inches
above the downrod. Strip
1
/
2
-inch insulation from the end
of each wire using a wire stripper (available at your local
hardware store).
Step 9. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side by
side and then securing with a wire nut. Test that the
connection is secure by pulling on the wire nut. Connect
in this order:
• GREEN leads from mounting plate and downrod
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire
in ceiling outlet box. Secure with wire nut
NOTE: If the color of your ceiling wires differs from
that described, consult an electrician.
CANOPY ELECTRICAL CONNECTIONS
Step 10a. Tuck the wires into the canopy with the wire
nuts pointed upwards, so that the WHITE and BLACK
wires are on opposite sides of the canopy and all wires are
clear of the canopy opening.
Step 10b. Install the canopy hatch with the last canopy
screw and lock washer using the provided screwdriver. To
do this, tilt the fan body away from the hatch opening.
Tighten the screws firmly.
Step 10c. Straighten the fan, then check to ensure there is
no movement between the canopy and the ceiling or the
Perma•Lock
™
downrod and the ball assembly.
CANOPY HATCH INSTALLATION
Ball
Slot
Pin
Wire Nut
2 Black
Wires
2 White
Wires
3 Green
Wires