Filter
Top Products
17
®
3
AUTOMATIC DEMONSTRATION PROGRAM
A multi-tone signal will verify the start of the test pro-
gram which proceeds as follows:
• Lights slowly increase to full intensity.
• Fan accelerates to speed three with audio tones.
• Light dims to half intensity.
• Fan accelerates to full speed with audio tones.
• Fan reverses at full speed with audio tones.
• Fan operates at full speed.
• Fan turns off with audio tones (blades coast for a
short time).
• Lights turn off.
The complete cycle lasts slightly over one minute. It
will continue to repeat until the is turned off
for more than ve seconds, cancelling the program.
Programmed into every Inteli-Touch
®
Series fan is an
Automatic Demonstration Program. It can be used to
fully demonstrate and test the operation of the fan.
To enter the demonstration program:
1. Turn off for at least 5 seconds. This will
clear the fan memory ready for programming.
2. Turn on.
3. Immediately operate the buttons in the following
sequence:
+
+
+ +
OPERATION SAFE-EXIT
®
AND LIGHT-MINDER
®
PROGRAM
NOTE: Both Light-Minder and Safe-Exit programs will always run at the same time.
The Light-Minder Program automatically turns OFF the fan mounted lights after two
hours.
To enter the Light-Minder Program:
1) To operate the lights for Light Minder Program – Press the button off for at
least 5 seconds.
2) Turn the on. Immediately press the buttons in the following sequence:
+ + + . A series of tones will be heard through the piezo-buzzer
indicating the command has been accepted. Once the lights turn on, they will auto-
matically turn off after 2 hours.
3) Light operation still remains normal, if you leave the room and turn OFF the lights
will blink to indicate this Safe-Exit command has been accepted. The lights will stay
on for 30 seconds and then begin to dim. After thirty seconds have elapsed, the lights
will turn completely off.
4) To cancel the Light-Minder and Safe-Exit Programs, press the button.
The Safe-Exit Program gives you about thirty seconds of light when you turn the lights off, enabling you to exit your
home before the lights go out. To enter the Safe-Exit Program:
1) To operate the lights for Safe-Exit Program – Press the button off for at least ve seconds.
2) Turn the Power on. Immediately press the buttons in the following sequence: + + + .
The Button should be immediately press after an audio tone is heard from the fan controller. The lights shall
blink to indicate this command has been accepted. The lights shall stay on for 30 seconds and then begin to dim.
After thirty seconds have elapsed, the lights shall be completely off.
3) To cancel the Safe-Exit Program, press the button off for ve seconds.
NOTE: If the lights are left on in the room, the lights will automatically turn OFF after 2
hours. ( this is Light-Minder)
Light-Minder
Safe-Exit