Filter
Top Products
12
®
3
Figure #5
ALMOND
BEZEL
RUBBER KEY
PAD
Figure #6
ALMOND
BEZEL
Figure #4
BEZEL
TABS
ALMOND
BEZEL
Prepare for W-84 Wall Control installation -
Continued
Step 1d. Before attaching the bezel back on to the
front of the switch, make sure that the rubber key
pad is attached to the locating pins on the bezel as
shown in Figure #4.
Step 1e. To attach the bezel back onto the front of the
switch you will need to align the four (4) tabs on the
bezel with the front of the wall control.Gently press
on both top and button of the bezel at the same time,
snap the bezel back on to the front of the switch as
shown in both gures #5 and #6.
Step 1f. Check your work by pressing on the light,
fan, reverse and power buttons, making sure that the
buttons do not stick and that each switch functions
properly.
LOCATING
PINS
(4)
BEZEL
TABS
BEZEL
ALIGNMENT
PIN AND HOLE