Filter
Top Products
4
CEILING HARDWARE (not to scale)
WAR NI NG!
Support directly to building structure only.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fi xture and disconnect
the wiring. Check the ceiling fi xture outlet box to be sure
that it is marked “Approved for Ceiling Fan Mounting.” If
it is not, a new box must be installed.
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fi xture located where you wish
to place your Casablanca fan, an approved ceiling fi xture
outlet box must be installed and wired.
Note: e weight of this fan is 34 pounds.
Note: After removing the old fi xture, check the outlet box
to ensure it is supported by a joist or beam across its upper
surface. If not, a 2"x4" stud must be installed.
Step 1a. Remove the knockout plug in the center of the
outlet box or drill a
1
/
2
-inch hole for the lag screw to pass
through. en drill a
1
/
4
-inch guidehole into the joist or
beam to a depth of 3 inches.
Step 1b. Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket as shown. Attach
the crossbar mounting bracket to the outlet box with the
screws provided, assuring that the outlet box wires are not
pinched by the washer.
CAUTION:
To reduce the risk of personal injury, use only the
mounting hardware provided with the approved
outlet box to install the crossbar mounting
bracket.
Crossbar Mounting Bracket
Wire Nuts (4)
Joist
Ceiling-Fan-Ap-
proved Wiring
Box
Ceiling Wiring
Crossbar Mounting
Bracket
Green Ground Wire
Ridge side down
1" x 8-32
Roundhead Screw
Washer
Pack A:
Lag Bolt & Washer (1),
Crossbar Screws & Washers (2)
WAR NI NG!
To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked
“Acceptable Fan Support of 22.7 kg (50 lbs.) or
less” using the mounting hardware provided with
the outlet box.
FAN INSTALLATION
GETTING STARTED
CROSSBAR MOUNTING BRACKET INSTALLATION