Filter
Top Products
Page 2 62-61138-20 (02/03)
INTRODUCTION
This manual is a guideline for the installation and use of the DataCOLD 500 T/R temperature recorders. To avoid
loss of warranty coverage due to incompetent installation it is most essential to follow the instructions and
recommendations of this manual.
DataCOLD 500 T/R recorders are developed and produced to conform to the applicable European and National
norms for the delivery of chilled and frozen foods in transport vehicles.
DataCOLD 500 T/R recorders are tested and approved to the European EN12830 specification meeting the
objectives of directives 92/1/EU and 93/43/EU and "e" mark approved following directive 95/54/CE.
DataCOLD 500 T/R can provide evidence of correct temperatures for every trip in the form of a delivery ticket,
numerical or graphical print out. All data is stored with a date/time stamp in a large flash memory. Data will not be
lost if power supply is disconnected. The real time clock is powered by an internal back-up battery.
The two recorder versions DataCOLD 500 T/R differ in looks. The R-Version is suitable for in-cab installation and
the T-Version for outside mounting on a trailer. Both versions are available with or without integrated printer. A
printer can be retrofitted at any time, the recorder has been designed already with hardware- and software.
DataCOLD 500 R
The R-Version has been developed for mounting in the truck cab. The chassis of the recorder meets the
dimensions of a DIN car radio and can be easily mounted in a free available radio slot. On the back side the
connectors are designed for up to 4 Temperature sensors and 4 digital inputs, a power supply and digital outputs
and a serial communication connector ( RS-232 ). If no free radio slot is available, the use of the optional universal
mounting kit is strongly recommended.
DataCOLD 500 T
The T-Version has been developed especially for mounting outside on a body or trailer. The unit is fixed into a
water proof enclosure. As on the R-version the connectors are on the back of the unit. Cabling is installed through
watertight cable glands.
Both products are produced by Carrier Transicold in Germany. Carrier Transicold has a policy of continued
development and improvements. Therefore products, manuals and technical information are subject to change
without prior notice.