Filter
Top Products
5-1
Section 5. Software Installation and
Settings
5.1 Measure Sensors and Process Data
A pre-written datalogger program (PN 14079) comes installed in the
TLX106. This program sets the scan rate, measures the sensors,
processes internally and stores the data. This program will be factory
corrected for the station’s latitude, longitude, elevation, and standard
time meridian, and then downloaded to the station before shipping.
5.2 Software Install and Settings
Install Proline and make sure to select the Weather Source install using
the install procedure. The user must have purchased the Weather
Source as an option to their ProLine software package.
Install LoggerNet according to the manual (refer to the LoggerNet
manual). Set up the communication link to the logger with the Network
Editor as shown below. (This is for the phone modem with AC
powered station; other setup combinations may vary slightly, but they
will be very similar.) Start the LoggerNet server by clicking on the blue
icon. Make sure Communications Enabled is checked and the proper
Com Port Connection is selected. Enter 10 seconds in the Extra
Response Time box. Click on the Apply button and proceed to the next
step.