Filter
Top Products
Pressure Washers
14
www.chpower.com
High Pressure Soap Lance
Safety Section
This manual contains information that is very important to
know and understand. This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS. To help recognize this
information, observe the following symbols.
Warning indicates a potentially hazardous
situation which, if not avoided, COULD
result in death or serious injury.
C
aution indicates a potentially hazardous
situation which, if not avoided, MAY result
in minor or moderate injury.
Notice indicates important information
information that, if not followed, may
cause damage to equipment.
• Do not spray flammable liquids such as gasoline.
• Never place eyes or face close to water spray or attachments.
• Keep away from children. This product is not intended for
recreational use by children.
• Do not drink from this device.
• To prevent water supply contamination, only use this product
when a back flow prevention device is present.
The High Pressure Soap Lance is an accessory that connects to
the gun of your pressure washer. With this device you can
spray liquid soap at high pressure from a tank conveniently
attached to the lance, or you can spray soap at low pressure
from the existing soap injection system on your pressure
washer. Use the high pressure soap spray to get to those hard-
to-reach areas on your house, truck or RV. Use the low
pressure spray for gentle soaking of your vehicle, patio, or
deck.
If lance is not already attached to the tank ...
1. Place the tank on a sturdy, flat surface. Then wedge metal
shaft of lance between the three “fingers” on top of tank
(see Figure 1). NOTE: The fit is very tight. Use caution to
prevent damage. Heating the center finger with a hair
dryer will make installation easier.
2. Slide free end of connector tube onto hose barb attached
to head of lance (see Figure 1).
!
CAUTION
!
WARNING
NOTICE
!
CAUTION
!
WARNING
3. To attach lance to spray gun, push brass end of lance
into gun and twist.
• Follow manufacturer’s label directions for correct concentration
of soap/detergents.
• When not in use, always keep in “off” position to prevent
leakage.
• To prevent accidental exposure to cleaning chemicals or
possible leaking, do not store detergent in tank when not in
use.
1. Slide connector tube off hose barb.
2. Optional: For easier filling, detach tank from lance.
3. Remove cap assembly by rotating cap counterclockwise
1/4 turn to align arrow on cap with tab on tank (Figure
2). Pull cap off.
4. Add cleaning solution (Figure 3). See manufacturer's
instructions for information on specifications and proper
use of cleaning solution.
5. To replace cap, align arrow on cap with tab on tank,
then push cap on and turn clockwise 1/4 turn until it
locks into place.
6. If tank was removed, reattach it to metal shaft of lance.
7. Reattach free end of connector tube to hose barb.
!
CAUTION
NOTICE
Description
Figure 1
Assembly Instructions
Hose barb
Connector
tube
“Fingers”
To Fill Soap Tank
Figure 2
Figure 3