2009 Spa Wraps
LTR20091032, Rev. A
Installing Your Spa Wrap Fireplace
www.calspas.com
8
Natural Gas Requirements
Always check the rating plate to make sure the gas
supply you are hooking up to is the gas type the
replace is manufactured for.
IMPORTANT WARNING: All Cal Flame replaces are
manufactured with the highest regard to safety. For
this reason, Cal Flame s and replaces are either
manufactured to operate on liquid propane (LP) or
natural gas (NG) and cannot be converted. To verify
the operating fuel, remove the bottom drip pan and
check serial number label on the left. Either LP or NG
will be marked on the operating tab, indicating the
proper operating fuel.
Attempting to convert a Cal Flame replace from one
fuel to another may result in serious injury and void
the warranty coverage.
IMPORTANT: Never connect the replace to an
unregulated gas supply.
The installation of this appliance must conform with
local codes or, in the absence of local codes, to the
national fuel gas code, ANSI Z223.1a-1998. Installation
in Canada must be in accordance with the standard
CAN/CGA-B149.2, Propane Installation Code. Natural
gas connection must be performed by a licensed
contractor or local gas company representative.
Ensure that the service supplying the replace is tted
with a conveniently positioned shut off valve with easy
access.
Your Cal Flame replace for use with natural gas
comes equipped with its own regulator which MUST
NOT be removed. If this regulator needs to be
replaced, use only the type specied by Cal Flame for
this appliance.
Remove the rear panel to gain access to the •
regulator and gas connection point.
Connect a suitable ex connector to the •
regulator.
What To Do If You Smell Gas
Do not try to light the appliance.•
Do not touch any electric switch. Do not use any phone in the immediate area.•
Immediately call your gas supplier from a neighbor’s phone. Follow the gas •
supplier’s instructions.
If you cannot reach your gas supplier, call the re department.•
Use only your hand to turn the gas control knob. Never use tools. If the valve will •
not turn by hand, don’t try to repair it -- call a qualied service technician. Force
or attempted repair may result in a re or explosion.