Filter
Top Products
OPERATION
RMB 1445 11/10 Operation Section 4-37
© 2010 Alamo Group Inc.
OPERATION
11.6 Operating the Attached Mower Heads
Refer to the Assembly Section of this manual to ensure the head is properly attached to the boom hitch and
hydraulic lines are properly connected.
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in heavy brush
and in heavy weeds. The Blades of this Mower can throw objects if
shields are not properly installed and maintained. Serious injury or even
death may occur unless care is taken to insure the safety of the operator,
bystanders, or passersby in the area. Do not operate this machine with
anyone in the immediate area. Stop mowing if anyone is within 300 feet
of mower.
(SGM-02)
Grass Flail
• The Grass Flail head is rated for cutting grass
and small brush up to 1-1/2”.
• The Grass Flail operates attached to the boom
arm, and is ideal for cutting hard to reach
areas where a smooth cut is required.
• Cutting height ranges from 3/4” to 4” in
vegetation. Cutting height is set by adjusting
the height of the roller assembly.
• When operating near the ground or when
mulching be particularly careful that there are
no bystanders or animals with a 300 feet.
Debris tends to fly out at great speed and can
injure or even cause death. OPS-B- 0040_B
Sickle Bar
• The Sickle Bar Cutter will cut a 5’ swath
through tough weeds and grass.
• The Sickle Bar Cutter is operated attached to
the boom arm and is ideal for vegetation
maintenance
• When operating the Sickle Bar correctly it will
give you a fast, efficient, and cost-effective
method of vegetation maintenance.
• The Sickle Bar will also cut vegetation through
tough weeds under water, ideal for maintaining
ponds, creeks, and other areas that may be
under shallow water.
• When operating the unit be sure there are no
bystanders or animals within 300 feet of the
unit
. OPS-B- 0049