Filter
Top Products
GEN2000LP 2000 Surge Watt / 1350 Running Watt Portable LP Generator Manual
13
Step 2 – Connect Fuel
Sulfur, water, dust, etc. are harmful for engine. If the gas supply source (LPG) contains these harmful elements, user must use filter to remove sulfur,
water etc. and clean gas. Otherwise, the engine service lifetime will be shortened.
Connect Propane Gas Supply Source
Step 1: Keep gas supply source closed.
Step 2: Fix two clips on the both ends of approved gas pipeline.
Step 3: Attached the gas pipeline to GAS INLET and gas supply source.
Step 4: Use screwdriver to tighten the clip at each end of gas pipeline until it’s not easy to pull
down from gas pipeline and prevent gas leaking.
All gas pipe joints should be tightly secured before operating the machine.
Check the joints and gas hose for leakage or breaks, replace the damaged joints and hose if necessary.
Check the gas pipeline for any damages every 18 months.
Place the LPG cylinder vertically.
Pre-Operation Check List
Step 1 Check that the gas supply source is in good condition. Check that the gas inlet connection is tightly fixed and not leaking.
Step 2 CHOKE VALVE GRIP is at CHOKE (CLOSE) position. The generator may be hard to start if CHOKE VALVE GRIP is at RUN
(OPEN) position.
Step 3 Check if engine oil is full.
Step 4 Make sure GROUND TERMINAL is properly grounded.
Step 5 AC CIRCUIT BREAKER must be at OFF position
Step 6 AC OUTPUT no load connected.
Disconnect all electrical loads from the generator set before starting the engine. The generator may be hard to start if a load is connected.
Step 7 DC OUTPUT no load connected.