Filter
Top Products
3 8
Step 3
Slide the two slots in the back of main
housing onto the screws.
Step 4
Select a location within 15 feet from the
main housing to mount the solar panel
module. The solar panel module must be
mounted where it will receive full, direct
sunlight for several hours each day.
Step 5
Firmly plug the solar panel module cord
into the main housing.
Step 6
Mount the solar panel module in a sunny
location where it will receive full, direct
sunlight for several hours each day.
NOTE: Shaded areas will not allow the solar
panel to fully charge the battery. This
will drastically reduce the number of
activations per night.
Step 7
Aim the solar panel toward the south, fac-
ing upward at about 45° angle. The
adjustable base allows mounting on most
vertical, horizontal or sloping surface
such as a wall, post or roof. Excess cord
can be tucked under the base securely.
45°
NOTE: After installing the main housing and
solar panel module, leave the switch
in the “OFF” position and charge in
full, direct sunlight for THREE FULL
DAYS. Then remove the switch label
and slide the switch to the “AUTO”
position. The light will turn on auto-
matically at night when it detects
motion.
Troubleshooting &
Important Information (con-
tinued)
IMPORTANT: The sealed battery in this
product contains lead and
must be recycled or disposed
of properly. For additional
information regarding dispos-
al, contact your local county
solid waste authority.
b. If the weather has been cloudy or overcast during the day, the bat-
tery will not be charged for operation at night. The light must have
direct sunlight every day to fully charge the battery. If the light does
not receive enough sunlight one day, it will recharge the next sunny
day and resume normal operation.
c. Check the battery on a voltage meter to ensure that battery is
charged to a full voltage of 6-volts. An electronics store will usually
check batteries at no charge. Battery should be replaced periodically
throughout the year, especially after winter months.
d. Diminishing light or gradual decrease in number of activations indi-
cate a dying battery that requires replacement. Replacement battery
may be purchased from The Brinkmann Corporation Customer Ser-
vice Department by calling 1-800-468-5252.
• Loose or burned out bulb. Bulbs can become loose over time. Check and
tighten the bulb periodically. If the bulb has burned out, a replacement
can be easily installed. Replacement bulbs may be purchased from The
Brinkmann Corporation Customer Service Department by calling 1-800-
468-5252.
• Dirty Solar Panel. A dirty solar panel will not allow the battery to fully
charge. This will shorten battery life. Clean regularly with a dampened
cloth or paper towel.
If lights come on randomly:
• Aim motion detector head lower.
• Cover areas which may be reflecting signals to motion sensor such as:
cooling or heating ducts, reflective surfaces, metal sheds, smooth walls
or windows, etc..
• Rotate the detector head right or left a few degrees.
• Mount your motion detector on a firm surface as vibrations can false
trigger the unit.
• Aim detector away from busy streets or sidewalks, trees and bushes.
If range is too short or too long:
• Position your motion detector so movement is across detection zone.
• Aim detector upward to increase range or downward to decrease range.
CAUTION: Do not use any other battery size or type. It will damage the
unit and void the warranty. Do not attempt to open the detector
housing. There are no user serviceable parts inside.
INSTR-SM SL-7.q 4/22/02 11:29 AM Page 4