Filter
Top Products
47
Step 8
Point the two floodlights in the desired
direction. You may want to adjust the
floodlights after letting the unit operate
for a few nights.
Step 9
Position the detector head in the direction
you want to cover. Never
aim the motion detector head directly
at the sun or above a 90° angle (horizon-
tal level). Do not rotate the
head more than 360°.
The motion detector covers an area of
130° and a maximum range of approxi-
mately 75 feet unless its view is blocked
by a stationary object such as a building
or tree. The higher the motion detector is
mounted, the greater the effective range.
The motion detector is most sensitive to
persons or warm objects moving across
its detection zone, rather than toward or
away from it.
1. Clean snow and debris off the solar panel so the battery can recharge.
2. Check and replace battery periodically throughout the year, especially
after winter months.
Wintertime
Tips
Solar security lights can be left outside year round, even in cold weather.
However, if you wish to store your light indoors for more than two or three
days, follow these steps to prevent damage to battery:
1. Turn the switch to “OFF” position. Store at room temperature in a
dry area.
2. Never store unit with switch in “AUTO” or “TEST” position. This will
damage the battery and it will not recharge.
3. Store light and solar panel where it can receive some sunlight or
room light each day. The battery needs light to maintain a charge dur-
ing storage.
4. During prolonged storage, unit must be fully charged once every four
months. You may need to replace the battery after prolonged storage.
5. Never store the unit in a box or in a dark room without a source of light
on the solar panel or you may need to replace the battery before next
use.
6. For best performance, do not store for prolonged periods.
Storage
Cleaning
It is important that the solar panel is kept free of dirt and debris. A dirty
solar panel will not allow the battery to fully charge. This will shorten the
life of the battery and cause the light to malfunction. Clean regularly with a
dampened cloth or paper towel.
75 Feet
90°
Motion Detector Head
If lights blink on and off:
• Direct lamps away from detector or reposition detector.
• Remove heat sources located near or under detector.
• Direct detector away from streets or active sidewalks.
If lights do not turn on at night:
• Switch is in the “OFF” Position. When the switch is in the “OFF” posi-
tion, light will not turn on after dark. Move switch to the “AUTO” posi-
tion and check for normal operation after dark.
• Make sure the solar panel module cord is plugged firmly into main
housing. The battery will not charge if this connection is loose.
• Battery is not fully charged or needs replacement:
a. Make sure light is located in an area where the solar panel gets the
maximum amount of full, direct sunlight every day.
Troubleshooting &
Important Information
Solar Panel
Module Cord
INSTR-SM SL-7.q 4/22/02 11:29 AM Page 5