Briggs & Stratton HU80931 Pressure Washer User Manual


 
9
INSTALLING THE TELESCOPING HANDLE
See Figure 3.
To install the telescoping handle:
Align the arrows on the U-shaped handle with the arrows
on the back of the frame.
Push and hold the button on the handle as you slide the
handle into the holes in the frame.
Lock the handle in place by aligning the slot in the handle
lock cap with the pin on the housing bar. Next, push the
handle lock cap down while turning the cap clockwise.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the handle
in place.
ASSEMBLY
Fig. 2
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
NOTE: Do not start the pressure washer until the engine has
been filled with oil, all hoses are connected, and the water
is turned on. Running this machine without oil will damage
the engine; running this machine without water will damage
the high pressure pump.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
To attach the wheels to the pressure washer base:
Locate the axle, hitch pins, and wheels. Remove the hitch
pin from the axle.
Slide the axle/washer through the hole in the center of
the wheel.
Lift the machine and slide the combination into the wheel
mounting hole in the machine base as shown.
Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
Repeat with the second wheel.
HITCH
PIN
AXLE
Fig. 3
PUSH TO
INSERT
HANDLE
LOCK CAP
WASHER