Briggs & Stratton HU80931 Pressure Washer User Manual


 
8
FEATURES
KNOW YOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
BRIGGS & STRATTON ENGINE
This Briggs & Stratton 500 Series engine enables the pres-
sure washer to achieve 2,200 PSI (pounds per square inch)
at a rate of 2.0 GPM (gallons per minute).
FUEL TANK
This fuel tank has a maximum capacity of 1 quart
(.95 liters). Use unleaded automotive gasoline in the
engine.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the front of
the machine using the hook and loop strap for convenient
storage.
OFF SWITCH
To turn the engine off, press and hold the OFF switch for a
full three seconds or until the engine stops.
RECOIL STARTER
The recoil starter is pulled to start the machine.
SPRAY WAND
The spray wand has a gripping surface that provides added
control of the spray wand and helps reduce fatigue. Both
the spray wand and extension have storage areas located
on top of the machine.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of water
from a rubber hose. Once the water has drained, the thermal
relief valve will reset itself.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.
UNPACKING
This product requires assembly.
Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-866-340-3912 for assistance.
ASSEMBLY
PACKING LIST
Pressure Washer
20 ft. High Pressure Hose
Spray Wand Assembly (upper)
Spray Wand Extension (lower)
Quick-Connect Nozzle (3)
Nozzle Cleaning Tool
Injection Hose
Wheel (2)
Flat Washer (4)
Axle (2)
Hitch Pin (2)
4-Cycle Engine Oil (SAE 30)
Telescoping Handle
Operator’s Manual