Filter
Top Products
11
ASSEMBLY
ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the injection
hose must be attached.
Push the open end of the clear injection hose securely
over the fitting as shown in figure 6.
Place the filtered end of the injection hose in the bottle
of detergent.
ASSEMBLING THE SPRAY WAND
See Figure 7.
To attach the spray wand extension:
Place the threaded end of the wand extension in the con-
nector on the end of the spray wand assembly.
Turn the connector clockwise until it stops. This secures
the wand extension in place.
When not in use, remove the spray wand extension from
the spray wand by turning the connector counter clock-
wise. When not in use, store both pieces on top of the
pressure washer.
CONNECTING HIGH PRESSURE HOSE TO
SPRAY WAND ASSEMBLY
See Figure 8.
Screw the collar on the high pressure hose into the spray
wand’s inlet coupler by turning the hose collar clock-
wise.
Pull on the hose to be certain it is properly secured.
Fig. 7
Fig. 8
COLLAR
HIGH PRESSURE
HOSE
INLET
COUPLER
SPRAY
WAND
EXTENSION
CONNECTOR
SPRAY
WAND
GROOVED
GRIPPING
SURFACE
INJECTION
HOSE
FITTING
Fig. 6