Briggs & Stratton HU80931 Pressure Washer User Manual


 
13
OPERATION
APPLICATIONS
You may use this tool for the purposes listed below:
�Removing dirt and mold from decks, cement patios, and
house siding
�Cleaning cars, boats, motorcycles, outdoor furniture, and
grills
STARTING AND STOPPING THE PRESSURE
WASHER
See Figures 11 - 12.
CAUTION:
Do not run the pump without the water supply connected
and turned on.
Before starting the engine:
Connect all hoses.
Check all fluids (oil and gas).
Turn the garden hose on then squeeze the trigger to
relieve air pressure; hold the trigger until a steady stream
of water appears.
To start the engine:
Push primer bulb 3 times.
NOTE: If starting the engine for the first time, push the
primer bulb 5 times.
Grasp the recoil starter and pull slowly until resistance is
felt. Give the recoil starter a short, brisk pull to start the
engine.
To stop the engine:
On the top of the engine is an OFF ( O ) switch. Press and
hold the switch in the
OFF position for three (3) seconds or
until the engine stops.
Fig. 12
Fig. 11
RECOIL
STARTER
PRIMER BULB 3X
OFF SWITCH