Filter
Top Products
7
Figure 6
SECTION 4: OPERATING THE EDGER
The operation of any edger can result
in foreign objects being thrown into
the eyes, which can result in severe
eye damage. Always wear safety
glasses or eye shields. We
recommend wide vision safety mask
for over spectacles or standard
safety glasses
WARNING: Do not lower blade if blade is
over concrete, asphalt, rocks or the like. The
blade can strike the supporting surface,
resulting in personal injury or property
damage.
Adding Gasoline And Oil
Service the engine with gasoline and oil as instructed in
the Briggs & Stratton Owner/Operator Manual packed
with your edger. Read instructions carefully.
WARNING: Never fill fuel tank indoors, with
engine running or until the engine has been
allowed to cool for at least two minutes after
running.
Starting The Engine
NOTE: Refer to the Briggs & Stratton Owner/Operator
Manual packed with your edger for a detailed
description of all engine-related controls and
components.
To start the edger’s engine, proceed as follows:
• Attach the spark plug wire to the spark plug. Make
certain the metal cap on the end of the spark plug
wire is fastened securely over the metal tip on the
spark plug.
• Move the blade clutch/depth control lever back to
the disengaged position, and place it in the
adjacent (top) notch.
• Move the choke control lever on the engine into the
CHOKE or START position.
• Move the throttle control lever on the engine into
the FAST (Rabbit) position.
• Grasp the starter handle and slowly pull the rope
outward until engine reaches the start of its
compression cycle (the rope will pull slightly harder
at this point).
• After slowly allowing the rope to recoil, pull the rope
with a rapid, continuous, full arm stroke. Keep a firm
grip on starter handle throughout the entire stroke.
• Allow the starter handle to slowly recoil into the
engine.
• Slowly move the choke control lever on the engine
into the RUN position after the engine has started.
Stopping The Engine
To stop the edger’s engine, proceed as follows:
• Move the blade clutch/depth control lever back to
the disengaged position, and place it in the
adjacent (top) notch.
Throttle Control &
Choke Control
Blade Clutch /
Depth Control Lever
Pull Rope / Recoil Starter
Blade Angle
Adjustment Lever
Curb Height
Adjustment Lever
WEAR YOUR
FORESIGHT IS BETTER
THAN NO SIGHT
SAFETY GLASSES