Filter
Top Products
6 Section 2: Assembly
STEP 6: CONNECT AND CHARGE
BATTERY (ELECTRIC START
MODELS)
1. Lift and tilt debris shield (X, Figure 2-
5) forward to view battery (P). Connect
the red wire (R, Figure 2-6) to the positive
(+) red-coded terminal on the battery.
Then, connect the black wire (S) to the
negative (–) black-coded terminal on the
battery. Close the debris shield (X, Figure
2-5).
2. Connect the small plug (U, Figure 2-7)
on the battery recharger cord to the wire
harness plug (V) located near the
keyswitch. Then, plug the charger box
(W) into a grounded, 220V wall outlet.
3. Charge the battery for 24 hours. After
charging, first unplug the charger box (W)
from the wall outlet, then disconnect the
recharging line plugs (U and V).
• Wet conditions can cause an electric
shock hazard during battery
recharging. Avoid wet conditions when
charging battery.
• Recharging the battery with improper
equipment could cause a battery explo-
sion. Use only the battery charger
shipped with the unit. The engine must
be shut off and the spark plug wire dis-
connected and moved away from the
spark plug.
Failure to comply could result in per-
sonal injury or property damage.
DANGER
S
R
Figure 2-6
V
W
U
Figure 2-7
X
P
Figure 2-5: Lift and tilt debris shield
forward to access battery.