Filter
Top Products
Section 2: Assembly 5
5. Use two cable ties (F, Figure 2-2) to
secure the trimmer head control cable (C)
and the electrical wiring harness (O) to
the handlebar at the locations shown.
STEP 3: ATTACH
THROTTLE CONTROL LEVER
1. One end of the Throttle Control Cable
(H, Figure 2-3) is attached to the engine.
Gently unwind the cable from its shipping
position and position the Throttle Control
Lever (I) on the outside of the right han-
dlebar, next to the throttle control decal.
2. Secure the Throttle Control Lever to
the handlebar with a 1/4-20 x 2 hex hd.
screw (J, Figure 2-3) and 1/4-20 hex
locknut (K).
3. Use a cable tie (L, Figure 2-3) to
secure the throttle cable (H) to the han-
dlebar at the location shown.
STEP 4: ADD MOTOR OIL
1. The engine is shipped without motor
oil which MUST BE ADDED before the
engine is started.
2. See the separate Engine Owner’s
Manual for filling instructions and for the
correct oil specifications. Engine must be
level when checking oil level. In ambient
temperatures above 40
0
F, use a high-
quality, SAE 30 weight detergent oil clas-
sified for Service SF, SG or SH. Use no
special additives. Do not mix oil with fuel.
STEP 5: CHECK
TRIMMER HEAD HARDWARE
Check that the two bolts (M, Figure 2-4)
on the trimmer head are tightened
securely. The trimmer head can be
rotated to make access to the hardware
easier.
IMPORTANT: The trimmer head hardware
is designed to be permanently installed
and is not removable. Do not attempt to
replace it with non-factory specified hard-
ware.
NOTE: The two holes (one is covered with
a plastic plug) on the top, front end of the
mower deck are access holes that allow
certain parts to be serviced.
Figure 2-2: Handlebar installation (electric start model shown).
A
C
D
E
B
G
F
O
M
M
Figure 2-4: Check trimmer head hard-
ware for tightness.
Figure 2-3: Attach throttle lever to right-side
handlebar.
I
J
K
L
I
H