Filter
Top Products
Fill Fuel Tank:
• Engine must be cool. Clean area around fuel tank cap and
remove cap. Insert a clean funnel into the fuel tank.
• Slowly pour gasoline/oil mixture into fuel tank. Fill tank no
higher than 1/2" from top of tank to allow for gasoline expan-
sion. Install fuel cap and clean up any fuel spills.
STEP 4: To Make Borders and Edges,
Install the Edger Attachment
To create borders or edges near walks, driveways, flower beds,
etc., you must remove the four tine sections and install the
Edger Attachment (this attachment was supplied with the unit –
see Page 6).
To Install the Edger Attachment:
• Collect the following parts (see Figure 4): (A) Border/Edger
Tine; (B) Long Bushing; (C) Border/Edger Wheel; and (D)
Short Bushing.
• Prop the machine carefully on the front of the tubular carrying
handle. The work surface should be firm and flat. NOTE:
Usually the Border/Edger Tine is mounted on the right-side of
the unit for right-handed persons, and on the left-side of the
unit for left-handed persons.
• Flip open the ring on the two ring lock pins (E, Figures 3 and
4) and remove the ring lock pin on each tine shaft.
IMPORTANT: The ring lock pin is under spring tension – wear
gloves to protect your fingers when removing or replacing the
ring lock pin.
• It is important for proper tilling performance that the tine
sections be later reinstalled in their original positions. There-
fore, mark the position of each tine section (Left-Outer, Left-In-
ner, etc.) before removing them. Refer to Figures 3 and 12 for
tine position information.
• Install the short bushing (D, Figure 4) on the right-hand or
left-hand tine shaft. Then place the Border/Edger wheel (C)
on the same shaft – the wheel hub should face toward the
tiller. Insert the ring lock pin through the rounded side of the
tine shaft and snap the ring down over the shaft (see
“DETAIL”, Figure 4).
• Slide the long bushing (B) on the opposite side shaft. Then
install the Border/Edger tine (A) and secure it with the ring
lock pin. See the Operation Section for information and full
instructions on using the Border/Edger Attachment.
ASSEMBLY
8
FUEL MIXTURE CHART
(Mixture Ratio is 24 parts gasoline to 1 part two-cycle oil)
U.S. Measure Metric Measure
Gas Oil Petrol Oil
1 Gal. 5 oz. 4 liters 167 ml
2 Gal. 11 oz. 8 liters 333 ml
Figure 3: Remove ring lock pins and tines from both sides of the
tine shaft. Keep left and right-side tines separated and marked for
easier reinstallation.
Figure 4: The Border/Edger tine (A) can be mounted on left or right
sides of machine (with long bushing B). The Border/Edger wheel
(C) mounts on the other side (with short bushing D).
A
B
E
E
C
E
D
DETAIL -Ring Lock Pin
This side
faces out
Contact with rotating tines or other moving parts can cause
serious personal injury.
Before installing or removing attachments, or adjusting or
servicing the machine, stop the engine, let all moving parts
come to a complete stop, disconnect the spark plug wire and
move the wire away from the spark plug.
WARNING