Filter
Top Products
CONTENTS OF HARDWARE PACK
6
(1) Border/Edger Wheel
(1) Short Bushing
for Border/Edger
(2) Bushings for Narrow Width Tilling
Parts bag contents (not shown full size)
Parts packed separately in carton (not shown full size)
(1) Border/Edger Tine
ASSEMBLY
Read these instructions in their entirety before you attempt to
assemble or operate your new equipment.
The Border Edger Attachment does not need to be installed until
you are ready to do edging projects (refer to instructions in this
Section).
To ensure safe and proper operation of your machine, all parts
and hardware you install or adjust must be tightened securely.
Use the correct tools to ensure proper tightness.
IMPORTANT: The correct mixture of unleaded automotive gaso-
line and two-cycle motor oil (a 24:1 ratio of gasoline to two-
cycle oil) must be added to the fuel tank before starting the
engine. See instructions in this Section.
UNPACKING INSTRUCTIONS
• Inspect your machine immediately. If you find or suspect
damage to the carton or contents, contact your local autho-
rized dealer or the Factory for assistance.
• Remove any packing material. Check for small parts before
discarding the packing material or carton.
• Perform the assembly on a clean, level surface. Be careful not
to severely bend any of the control cables on the unit.
• Before starting any assembly steps, disconnect the engine
spark plug wire from the spark plug.
TOOLS NEEDED FOR ASSEMBLY: An adjustable wrench and a
slotted-head and a Phillips-head screwdriver may be needed to
tighten any loose hardware.
ASSEMBLY STEPS
STEP 1: Unfold and Adjust Handlebars
IMPORTANT: Be careful not to pinch any wires or cables while
unfolding and adjusting the handlebars.
• Loosen the two handlebar knobs (A, Figure 1) and unfold the
handlebars into the operating position. Do not use force — if
there is binding, continue to loosen the knobs.
• There are two height settings holes in the upper handlebar.
The unit is shipped with the handlebar knobs in the lowest