Filter
Top Products
ASSEMBLY
TW120 01/11 Assembly Section 3-12
© 2011 Alamo Group Inc.
ASSEMBLY
Rear Chain Guards
Attach the right and left Chain Guard assemblies (1)
to the Cutter with 1/2” x 1-1/4” Bolts (2),
Flatwashers (3), and Locknuts(4).
CHECK CHAINS (EXTRA EQUIPMENT) FOR LIFT-MODELS
Check Chains are available for attachment to front of Cutter as an accessory. Check chains are used to control
cutting height and especially to allow Cutter to be lowered to the same preset cutting height effortlessly.
Install lower end of check chain (4) to hitch ears (6) through lower holes (7) using bolts, nuts and
lockwashers(8). Tighten securely.
Install chain lugs (3) on either side of tractor top link mounting (5) using bolt or pin of required diameter and
length. Cat I kit requires a 3/4” diameter bolt. Cat II kit requires a 1" diameter bolt. Install top end of check
chains in brackets (3).
Cutting height is then set by placing proper chain link in keyhole slot. Cutting height is easily adjustable by
hooking chain higher or lower in the keyholes in chain lug (3).
For additional safety in transport, raise Cutter as high as possible without having driveline hit
deck and shorten check chains as much as possible to prevent inadvertent falling in
transport.