Blue Rhino FC-0024 Brush Cutter User Manual


 
ASSEMBLY
TW120 01/11 Assembly Section 3-7
© 2011 Alamo Group Inc.
ASSEMBLY
HYDRAULIC OR MANUAL LIFT
Attach the Spring Assembly option (FIGURE Asm-R-0186) to the lug on the cutter deck behind the Center
Gearbox. Retain using 3/4 x 3 capscrew and locknut. Install the Hydraulic Cylinder (FIGURE Asm-R-0187) or
the manual Ratchet Lift Screw 1"x2 3/4 (FIGURE Asm-R-0187) between the Axle Center Lug and the Lug
directly behind the Center Gearbox. Tighten all Bolts securely.
WHEELS - PULL TYPE
Install the Wheels on the Wheel Hubs.
Note: If Laminated Tires are used, place the flat side of the Lug Nut against the Wheel. Note direction of travel
and curvature of rubber segments in tire and install as shown in FIGURE Asm-R-0127.