Filter
Top Products
6
• Contentsofopenedbatterycellsmaycauserespiratoryirritation.
Providefresh air.Ifsymptomspersist,seek medicalattention.
WARNING: Burn hazard. Battery liquid may be flammable if
exposed to spark or flame.
• Charge the battery packs only in Black & Decker chargers.
• DO NOT splash or immerse in water or other liquids. This may
cause premature cell failure.
• Do not store or use the tool and battery pack in locations where
the temperature may reach or exceed 105°F (40˚C) (such as
outside sheds or metal buildings in summer).
WARNING: Never attempt to open the battery pack for any
reason. If battery pack case is cracked or damaged, do not insert into
charger. Do not crush, drop or damage battery pack. Do not use a
battery pack or charger that has received a sharp blow, been
dropped, run over or damaged in any way (i.e., pierced with a nail,
hit with a hammer, stepped on). Damaged battery packs should be
returned to service center for recycling.
WARNING: Firehazard.Do notstoreor carry batteryso that
metal objectscancontact exposed batteryterminals.For example, do
notplacebattery inaprons, pockets,tool boxes,product kitboxes, drawers,
etc., withloose nails, screws, keys,etc.Transporting batteries can possibly
cause fires ifthebattery terminals inadvertentlycomein contactwith
conductive materials suchas keys,coins,hand tools and thelike.The
US Department ofTransportation Hazardous Material Regulations (HMR)
actuallyprohibit transportingbatteries in commerce oron airplanes (i.e.,
packedin suitcases and carry-on luggage)UNLESSthey are properly
protectedfromshort circuits.So when transporting individual batteries, make
surethatthe battery terminalsare protected andwellinsulatedfrom materials
thatcould contactthemand cause a short circuit.NOTE:Batteriesshould
notbeputin checked baggage.
STORAGE RECOMMENDATIONS
1. The best storage place is one that is cool and dry away from
direct sunlight and excess heat or cold.
2. Long storage will not harm the battery pack or charger.
CHARGING PROCEDURE
The standard charger provided will charge a fully depleted battery in
about 2 hours.
1. Plug the charger into an appropriate outlet before inserting the
battery pack.
2. Insert the battery pack into the charger
as shown in figure A.
3. The green LED will flash
indicating that the battery is being
charged.
4. The completion of charge is
indicated by the green LED
remaining on continuously. The pack
is fully charged and may be used at
this time or left on the charger.
Recharge discharged batteries as soon
as possible after use or battery life may be greatly diminished.
CHARGER DIAGNOSTICS
This charger is designed to detect certain problems that can arise
with the battery packs or the power source. Problems are indicated
by one LED flashing in different patterns.
BAD BATTERY
The charger can detect a weak or damaged battery. The red
LED flashes in the pattern indicated on the label. If you see
this bad battery blink pattern, do not continue to charge the
battery. Return it to a service center or a collection site for
recycling.
HOT/COLD PACK DELAY
When the charger detects a battery that is excessively hot or
excessively cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery has normalized.
After this happens, the charger automatically switches to the
Pack Charging mode. This feature ensures maximum battery
life. The red LED flashes in the pattern indicated on the label
when the hot / cold pack delay is detected.
A