Filter
Top Products
CHARGING PROCEDURE- FIGURES I, J, K
The battery can be removed from the tiller for charging
o
r left in place. To remove the battery refer to figure H.
CHARGING WITH BATTERY IN PLACE IN TILLER
1. Remove safety key I-1.
2. Align the charger plug I-2 with the arrow I-4 on top and
insert the charger plug into the receptacle I-3 on the
tiller (green terminal to green terminal, white terminal
to white terminal).
CHARGING WITH BATTERY REMOVED FROM TILLER
1. Remove safety key I-1.
2. With the battery removed, insert the charger plug J-1
(with the arrow on top) into the receptacle J-2 on the
battery. The charger connector can only be plugged into
the tiller receptacle or battery one way.
3. Insert the 120 volt plug K-1 of the charger K-2 into the
wall receptacle.
4. The red LED K-3 on the charger should come on
indicating you have power and the battery is being
charged. Check the charger for the red LED, if it is not
on check the charger connector for proper alignment
(step 2). The red LED should extinguish and the green
LED will come on when charging is complete (takes
approximately 20 hours to charge a fully discharged
battery).
5. It is recommended to leave the battery on constant
charge (between tiller uses) for optimum performance
during the tilling season.
9
I
J
K