Filter
Top Products
ASSEMBLY INSTRUCTIONS
UNPACKING - (FIGURE B)
Remove the frame / upper handle assembly, mid handle,
battery, wheels, drag bar, tines and hardware bag from the
carton.
The hardware bag contains:
1. Safety Key (1)
2. Long Carriage Bolts (2)
3. Short Carriage Bolts (4)
4. Flanged Hex Nuts (4)
5. Knobs (2)
6. Wheel machine bolts (2)
7. Wheel washers (4)
8. Steel Pin (1)
9. Long Hairpin Cotter Pins (2)
10. Short Hairpin Cotter Pin (1)
ASSEMBLY
DANGER: TO PREVENT SERIOUS PERSONAL INJURY, DO NOT INSERT SAFETY KEY UNTIL FULLY
COMPLETING GARDEN TILLER ASSEMBLY.
Tools required for assembly:
Adjustable or 10 mm wrench
MID HANDLE ASSEMBLY - (FIGURE C)
Ensurethatthecordis notpinchedandis routedonthe topsideofthehandles.
1. Align the holes in the mid handle with holes in the frame and insert the
short carriage bolts (C-1) through the holes. Be careful not to trap or
pinch cord
2. Place a nut (C-2) on each bolt and tighten securely with a 10 mm or
adjustable wrench.
UPPER HANDLE ASSEMBLY - (FIGURE D)
Ensurethatthecordis notpinchedandis routedonthe topsideofthehandles.
1. Align the holes in the upper handle with holes in the mid handle and
insert the long carriage bolts (D-1) through the holes. Be careful not
to trap or pinch cord
2. Hand tighten plastic knob (D-2) onto carriage bolts.
3. Clip the lower part of the cord into the lower cord clip (D-3) after the
handles are fastened together.
6
B
C
33
D