Filter
Top Products
BK Precision 4070A User Manual Rev.2.2
56
7.8.3 Digital Format
The Digital format was implemented as an easy way to design purely digital waveforms, i.e. waveforms that are
either high or low. The digital format provides a very efficient way of representing waveforms that assume only a
high or low value.
If the value of the data point is 0, then the SIG Out output is set to its minimum negative output voltage and the
SYNC Out output is set to the logic Low state (0V) for that point.
If the value of the data point is non-zero, then the output is set to its maximum positive output voltage and the
SYNC Out output is set to the logic High state (+5V) for that point.
All rules for this format are identical to those for Floating Point Format, except that the Time or Point Number
value need not be between +1.0 and -1.0 in value since the 4070A only sees if the value is zero or nonzero. Also,
the “P” character has no meaning since the SYNC Out output is controlled by the data itself.
With this format, it is possible to specify each point of a digital waveform with only two bytes (a “1” or a “0” and
a data separator character). This makes this format as efficient as binary format for data downloads. However since
the data consists entirely of ASCII characters, it is easier to work with than binary format.
Example
This twelve point digital waveform
0 1 0 0 1 1 0 0 0 1 1 1
will render the following waveform on both the SIG Out and SYNC Out connectors: