Filter
Top Products
Part No. 890207 Form No. F021795E
16.16.
16.16.
16.
1212
1212
12
Page 7 of 12
OPERATION 7
Bail Down
Disengages
Drive
Handle
Bail
GROUND SPEED can be varied by applying slight downward
pressure to handle during operation (to allow drive wheels
partial slippage) or by changing the engine rpm.
For improved control in confined areas, this machine can be
freewheel pushed forward or backward by releasing the
operator's bail and pushing machine.
This vacuum is self-propelled. To engage the drive, lift operator's
bail against operator's handle. The drive is disengaged by
releasing the operator's bail.
Never store engine indoors or in enclosed poorly ventilated
areas with fuel in tank, where fuel fumes may reach an open
flame, spark or pilot light, as on a furnace, water heater, clothes
dryer or other gas appliance.
If engine is to be unused for 30 days or more, prepare as
follows:
Be sure engine is cool. Do not smoke. Remove all
gasoline from carburetor and fuel tank to prevent gum deposits
from forming on these parts and causing possible malfunction of
engine. Drain fuel outdoors, into an approved container, away
from open flame. Run engine until fuel tank is empty and
engine runs out of gasoline.
store tamper in the chipper hopper.
Do not leave tamper on the ground,
Tamper Storage Position.
Using two people to lift machine is recommended. Lift holding the
handle and front of nozzle. Secure in place during transport.
NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable
alternative in minimizing the formation of fuel gum deposits
during storage. Add stabilizer to gasoline in fuel tank or storage
container. Always follow mix ratio found on stabilizer container.
Run engine at least 10 min. after adding stabilizer to allow it to
reach the carburetor.
Do not store with debris in bag.
Before turning machine off, use the Tamper to slowly push
remaining pieces of wood through the chipper. This can prevent
any remaining wood from jamming in the chipper when machine is
turned off.
1616
1616
16
16.416.4
16.416.4
16.4
16.516.5
16.516.5
16.5
OPERATION continued
PROPULSION
Bail Up
Engages
Drive
16.616.6
16.616.6
16.6
TAMPER
STORAGE
HANDLING & TRANSPORTING:
16.16.
16.16.
16.
1212
1212
12