Filter
Top Products
Part No. 890207 Form No. F021795E
Page 3 of 12
For your safety and the safety of others, these directions should be followed:
Use of Ear Protection is recommended while
operating this machine.
Do not operate this machine without first reading
owner's manual and engine manufacturer's manual.
Use of Eye and Breathing protection is recom-
mended when using this machine, especially in dry
and dusty conditions. Optional bag cover directs dust
toward ground, away from the operator.
·DO NOT place hands or feet inside nozzle intake opening,
near debris outlet or near any moving parts.
·DO NOT start engine without debris bag and quick discon-
nect connected firmly in place to exhaust outlet.
·DO NOT start or operate machine with debris bag zipper
open.
PUT OIL IN ENGINE BEFORE STARTING.
Read all safety and operating instructions
before assembling or starting this unit.
Denotes parts found in Parts Bag Assembly (shown on page 4).
Your Billy Goat is shipped from the factory in one carton,
completely assembled except for the debris bag, upper handle,
bag quick disconnect, tamper and bag support assembly.
8
73
74
Attach upper handle using
wingnuts, carriage bolts
and lock nuts already
assembled to handle stubs.
Debris Bag
900805
Check
Check
Check
Engine
Manual
These items should be included in your carton. If any
of these parts are missing, contact your dealer.
QUICK DISCONNECT
GENERAL SAFETY
& ASSEMBLY
3
Fig. 2
·DO NOT operate during excessive vibration.
·DO NOT remove bag until engine has been turned off and has
come to a complete stop.
·DO NOT remove hose kit cap on nozzle until engine has been
turned off and has come to a complete stop.
·DO NOT operate machine with hose cap, bag or hose removed.
·DO NOT use this machine for vacuuming exclusively sand,
dust, fine dirt, rock, glass, string like material, grain, rags,
cans, metal, bark or water.
·DO NOT operate this machine on slopes greater than 20%.
·DO NOT pick up any hot or burning debris, or any toxic or
explosive material.
·DO NOT allow children to operate this equipment.
9
80
Check
Tamper
890229
Check
Connector
Quick
Disconnect
890176
Bag Support
Assembly
900647
Handle Assy.
890204
GENERAL SAFETY
ASSEMBLY
PACKING CHECKLIST
99
99
9
1010
1010
10
1111
1111
11
Parts Bag &
Literature Assy
Check
Briggs & Stratton
P/N 272262 English
Check
Parts Bag &
Literature Assy
890206
1. ASSEMBLE upper handle securely to lower handle stubs using
handle screws (item 8), knob wing 5/16-18 (item 73), and nut lock
5/16-18 (item 74).
2. CONNECT bag support assembly (item 78), to rear axle (item 33),
of unit and to both sides of upper handle using clips on strap (item
80).
3. UNFOLD the debris bag (item 1), and fasten bag neck to bag quick
disconnect (item 83). Attach firmly to housing exhaust (item 52), see
fig. 2.
4. ATTACH upper bag hanger straps to loops (item 11), pre-as-
sembled to upper handle.
5. ATTACH throttle assy. (item 2), to handle, using cable clamps
(item 9).
6. INSTALL tamper in chipper hopper (see page 7).
7. CONNECT spark plug wire