Filter
Top Products
Part No 500402 8 F020513A
BC2403 Series Brush Cutter Owner’s Manual
4. Units equipped with electric starters: Pull up on the ON/OFF switch until engine starts.
ON/OFF (I/O)
(Manual start shown)
DO NOT START equipment with drive or blade clutch engaged.
5. Units equipped with manual starters: Pull starter rope to start engine.
PULL STARTER CORD slowly until resistance is felt. Then pull cord rapidly to avoid kickback.
6. Push choke in (Honda engine only).
7. Pull throttle control back to and allow engine to reach correct operating speed.
CUTTING
The best performance is achieved when cutting in dry conditions. The quality of the cut is directly related to ground speed
during cutting. Under most conditions cutting should be done in first or second gear. Third gear should be reserved for
conditions where weeds and brush are thinned out or not very tall. If the quality of the cut is not satisfactory, shift into a lower
gear.
1. Move shift lever to correct position (1, 2, 3 or Reverse) for desired gear.
Gear Shift Lever