Filter
Top Products
Part No 500402 17 F020513A
BC2403 Series Brush Cutter Owner’s Manual
TRANSAXLE DRIVE BELT REMOVAL AND REPLACEMENT
READ all safety instructions before servicing unit.
Numbers in parenthesis (N) refers to the item number in Illustrated Parts List.
Tools required: ½” socket and ratchet, ½” universal extension bar, pry bar or long screwdriver, adequate support for
machine.
- 1/2” socket, 3/8” drive
- ratchet, 3/8”
- drive extension, 3/8” drive
- universal joint, 3/8” drive
- pry bar or long screwdriver
- jack stands or similar device adequate to support weight of machine.
DISCONNECT spark plug wire before servicing unit.
1. Disconnect spark plug wire.
2. Lift and support rear of unit to allow access to underside.
UNIT IS HEAVY. Make sure support is adequate to support weight of machine.
3. Using drive extension and universal joint, loosen, but do not remove, four screws (107) holding belt guides (149, 150)
in place next to crankshaft drive pulley (9) at rear of machine.
If extension and universal joint are not available, remove stop bolt (10) and nuts (116, 117) to allow idler
arm to swing back and allow access to screws (107).
4. Pull belt (8-10) from groove on pulley (9) and down past pulley.
5. Slip belt (8-10) up and over pulley (9) and remove belt from machine.
6. Install new belt in grooves on pulley (46) and transaxle drive pulley (9).
7. Tighten four screws (107) to secure belt guides (149, 150).
8. Engage clutch levers and make sure belt guides do not touch belts.
9. Reconnect spark plug wire.