Filter
Top Products
Part No 500402 10 F020513A
BC2403 Series Brush Cutter Owner’s Manual
MAINTENANCE
PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals:
Maintenance Operation
Every Use
Daily or Every 5
Hours
Every 25 Hours
Every 50
Hours
Every 100-150
Hours
Inspect for worn or damaged parts.
Check for excessive vibration
Inspect for loose parts.
Sharpen blade.
Inspect belts for wear.
Lubricate throttle control cable and linkage.
Check blade clutch cable tension.
Inspect battery for corrosion, damage or leaks
(electric start units only).
Apply anti-seize compound to rear axles.
Check battery strap for excessive wear or rips
Replace blade drive and transaxle drive belts.
COMMON REPLACEMENT PARTS
- Blade. P/N 500210. Original equipment replacement blade.
- High Lift Blade. P/N 500102. Optional replacement blade.
- Traction Drive Belt. P/N 500119. Original equipment replacement drive belt.
- Blade Drive Belt. P/N 500237. Original equipment replacement drive belt.
- Skid. P/N 500355. Side deck skid.
- Throttle Control Assembly. P/N 500213. Throttle control assembly, including cable.
CLEANING
Your BILLY GOAT
®
Brush Cutter should be cleaned periodically to ensure optimum performance and service life. Clogs and
debris should be removed from the blade area and debris should be removed from the engine cooling fins. A garden hose or
pressure washer may be used for cleaning.
DO NOT SPRAY WATER DIRECTLY ON THE BLADE CLUTCH WHEN USING A POWER
WASHER. SEE FIGURE BELOW.