Filter
Top Products
Part No 500264 21 F083106A
BC2402 Series Brush Cutter Owner’s Manua
l
Make sure blade drive belt is properly seated in clutch/brake drive pulley (6-23) and is
not resting in gap between clutch/brake drive pulley (6-23) and transaxle drive pulley
(6-46)
12. Tighten four screws (6-103) to secure belt guides (6-149, 6-150).
Make sure belt is correctly routed. (See Figure 2).
13. Adjust blade drive belt tension by reaching in through top of engine base with pry bar or long screwdriver
and pushing idler pulley against belt to increase tension (see below).
Adjusting Blade Drive Belt Tension
14. While holding belt under tension tighten two nuts (6-116) securing idler plate.
15. Check belt tension by applying force on side of belt opposite idler pulley. Belt should deflect 3/16”-1/4” (4.8-
6.4 mm) with force applied perpendicular to belt.
16. Replace engine base door (6-7) and secure with screws (6-103) and washers (6-141).
17. Reconnect spark plug wire.
LOOKING THROUGH TOP
Belt Routing Diagram
(Top View of Machine)
Figure 2
Blade Drive Belt (with
Transaxle Belt not Shown)
Blade Drive Belt
(Between Transaxle Drive
Belt and Deck)
Transaxle Drive Belt
FRONT