Filter
Top Products
Part No 500264 11 F083106A
BC2402 Series Brush Cutter Owner’s Manua
l
OPERATOR CONTROLS
The operator’s station is at the rear of the machine between the handlebars. The operator should STAND in a
position to allow both handlebars to be grasped firmly and which allows sufficient leverage to steer the machine.
Operator’s controls are shown below.
Operator Control Locations
1 Blade Clutch Lever 5 ON/OFF Switch
2 Gear Shift Lever 6 Drive Clutch Lever
3 Choke 7 Pull Starter
4 Throttle
STARTING
CHECK engine oil level before operating machine.
1. Place equipment on a level, firm surface that is free of rocks or other debris.
2. Place throttle in START position.
Throttle
1
2
3
5
6
7
4