Filter
Top Products
Part No 500264 16 F083106A
BC2402 Series Brush Cutter Owner’s Manual
MAINTENANCE
PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals:
Maintenance Operation Every Use Daily or Every 5
Hours
Every 25 Hours Every 50
Hours
Every 100-150
Hours
Inspect for worn or damaged parts.
z
Check for excessive vibration
z
Inspect for loose parts.
z
Sharpen blade.
z
Inspect belts for wear.
z
Lubricate throttle control cable and linkage.
z
Check blade clutch cable tension.
z
Inspect battery for corrosion, damage or leaks
(electric start units only).
z
Apply anti-seize compound to rear axles.
z
Check battery strap for excessive wear or rips
z
Replace blade drive and transaxle drive belts.
z
CLEANING
Your BILLY GOAT
®
Brush Cutter should be cleaned periodically to ensure optimum performance and service
life. Clogs and debris should be removed from the blade area and debris should be removed from the engine
cooling fins. A garden hose or pressure washer may be used for cleaning.
DO NOT SPRAY WATER DIRECTLY ON THE BLADE CLUTCH WHEN USING A
POWER WASHER. SEE FIGURE BELOW.