Filter
Top Products
Part No 500264 14 F083106A
BC2402 Series Brush Cutter Owner’s Manual
Drive Clutch Lever
SHUT DOWN
1. Release drive clutch handle to disengage transaxle.
2. Release blade clutch handle to disengage blade.
3. Pull throttle control all the way back to the STOP position.
4. Place the ON/OFF (I/O) switch in the OFF (O) position.
CUTTING HEIGHT ADJUSTMENT
Cutting height can be adjusted to allow a 1” (2.54 cm) lower cutting height. This is particularly useful for cutting
grasses that tend to lay over when overgrown (i.e., Bermuda, Johnson, etc). When cutting brush and normal
field grasses it is recommended that you operate the brush cutter at the standard (top) cutting height.
1. Shut engine off and wait for blade to stop completely.
2. Disconnect spark plug wire.
3. Remove bolts, nuts and washers (items 119, 103, 107, 141 and 117) from skid items (155, 156). To lower
the cutting height, remount the skid with the hardware in lower holes on skid bracket. To raise the cutting
height use the top holes on the skid. Repeat for the opposite side. Tighten the hardware securely.
4. Reconnect the spark plug wire.
CLEARING A CLOGGED CUTTING DECK
1. Shut engine off and wait for blade to stop completely.
2. Disconnect spark plug wire.
3. Remove clog from cutting deck.
WEAR durable gloves. Clog may contain sharp materials.
4. Reconnect spark plug wire.
DISCONNECT spark plug wire before servicing unit.