Filter
Top Products
HYDROTHERAPY JETS
Your spa is equipped with the follow-
ing jets:
You can adjust the volume of water
from these jets by turning the face
plate clock wise to decrease the vol-
ume of water and counter clock wise
to increase it. You can also change the
direction of the water flow by pushing
on the side of the small orifice in the
centre of the trim kit.
You can adjust the volume of water
from the micro swirl jets by turning
the face plate 1/2 turn clockwise to
decrease the volume of water and
counter clock wise to increase it.
The micro-swirl jets on your spa are
interchangeable. To remove either
trim kit you must place a screwdriver
between the face plate and the acrylic
spa surface then push with a gentle upwards motion and the
trim kit will pop out of the jet body. To replace just place the
trim kit into the jet body and gently push it into place. Be
careful not to scratch the spa surface with the screwdriver
and do not force the trim kit into or out of the jet body. To
remove adjustable jets, pop them out an inch then unscrew
them.
WARNING:
All jet trim kits must be properly seated or
air flow may be restricted
14
Micr
Micr
o Swirl
o Swirl
Adjustable jets
Adjustable jets
Micr
Micr
o Dir
o Dir
ectional
ectional