Filter
Top Products
11
1) Make sure all of the jets are in the full open position, (refer
to Hydrotherapy Jets, page 13).
2) The Electronic Operating System spa control has automat-
ic functions that operate upon start-up and normal operation
to protect the system. Power up system and “Pur” will
appear for 30 seconds while system is in purge mode then
normal operation will resume.
3) With the breaker in the “On” position check to see if water
is circulating. If not then you must prime the pump. To prime
the pump turn union #1 slowly 1/2 to 1 turn to release air,
being careful not to open too far. After you hear the water
begin circulating, retighten the union. The pump must be
primed every time the water is changed. Check to see if
water is coming from all the jets.
4) At the end of the boot up, 30 seconds, the pump will be in
high speed until the water temperature reaches 52°F. If your
water temperature is below 39°F, at the time of fill, the top-
side control will toggle back and forth reading th2/39. The
pack system is in lockout and the pump will run in high
speed until the water temperature reaches 52°F. Once the
water temperature has reached 52°F, the pump will then run
in low speed. You can now set your water temperature to
your desired level.
Note: At the time of boot up, your spa will automatically go
through its first filtration cycle for 2 hours.
5) Press the pump button on the control panel to test if the
pump is changing from low to high-speed, (refer to Topside
Control Component Identification, next page). You will be
able to tell the difference between low and high-speed by the
sound of the water moving through the spa’s plumbing sys-
tem. Press the pump button again to return the pump to low
speed.
6) Once the water has reached the set temperature add chem-
HAZARD
This system should be set to maintain
a water temperature NO GREATER THAN
40° CELSIUS (104° F).