Ariens 932105 - 8526 , 932506 - 8526 Snow Blower User Manual


 
GB - 21
SCRAPER BLADE
IMPORTANT: Damage to auger/impeller
housing will result if blade wears down too far.
Scraper blade is adjustable to compensate for
wear.
To adjust scraper blade:
1. Tip unit back onto handlebar, support
housing and loosen nuts retaining blade.
2. Adjust runners to fully raised position
(housing closest to ground).
3. Reposition scraper blade flush with
runners and tighten lock nuts.
SHEAR BOLTS
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear
bolt may result in severe damage to unit.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger,
breaking shear bolts (Figure 15) which secure
the auger to the shaft. This allows auger to
turn freely on the shaft preventing damage to
gear drive.
For Replacement:
1. Align shear bolt holes in auger with shear
bolt holes in the shaft.
2. Drive shear bolt through hole (if shear bolt
was broken this will drive remaining part
from shaft).
3. Secure shear bolt with nut.
SPEED SELECTOR ADJUSTMENT
To adjust (Figure 16):
1. Remove hair pin from adjustment pivot pin.
2. Pull shift rod and adjustment pivot pin out
of speed selector lever.
3. Place the speed selector in the fastest
forward speed position.
4. Pull the shift rod straight down towards the
ground as far as it will go.
Figure 14
1. Runner
2. Runner Hardware
1
2
Figure 15
1. Auger
2. Shear Bolts
1
2
OS6780
Figure 16
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Lever
4. Hairpin
OSs0194
1
2
3
4