Ariens 932105 - 8526 , 932506 - 8526 Snow Blower User Manual


 
GB - 11
Deflector Remote
1. Remove e-ring and flat washer from stud
on discharge chute.
2. Route deflector remote cable between the
chute and the chute pedestal.
3. Slide cable end through hole on bracket on
left side of chute (Figure 7).
4. Attach cable eye to stud on deflector. Hold
in place with flat washer and e-ring.
5. Check deflector travel. Adjust nut on cable
end under handlebar to obtain full travel.
(See Deflector Remote in Service and
Adjustments.)
Check Function of Dual Handle
Interlock
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage. If they do not, contact your dealer
for repairs.
Check Tire Pressure
Check tire pressure and adjust to the pressure
listed on tire sidewall.
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Service
and Adjustments).
Check Engine Crankcase Oil
IMPORTANT: The engine is shipped with
5W-30 oil in crankcase. Refer to Engine
Manual for detailed instructions.
Fill Engine Fuel Tank
Refer to Engine Manual for proper fuel type
and tank capacity.
Check Function of all Controls
Ensure unit runs and performs properly. Refer
to Operation.
Figure 6
1. Spring Clip
2. Chute Crank Rod
3. Universal Joint
1
3
1
2
OS6640
Figure 7
1. Cable Eye
2. Flat Washer and E-Ring
3. Deflector Cable
1
2
3