Filter
Top Products
GB - 21
CLEAN BATTERY (924516, 517)
IMPORTANT: Battery is maintenance-free. Do
not tamper with or attempt to open battery.
See Service and Adjustments for charging
procedures.
Terminals
Keep battery and its terminals clean.
IMPORTANT: Remove battery from unit
before cleaning.
Remove corrosion from battery terminals and
cable connections with a wire brush, then
wash with a weak baking soda solution.
After cleaning, apply a thin coat of grease or
petroleum jelly to terminals and cable ends to
retard corrosion.
DEFLECTOR REMOTE
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath the control panel to
increase friction on pressure flange
(Figure 16).
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket.
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
1.Auger and Shaft
2.Discharge Chute
3.Sprocket/Pinion
Assembly
4.Axle Shaft
5.Shift Lever Arm
6.Pinion Chain
7.Hex Shaft
8.Shift Link
11
6
8
3
5
4
Figure 15
2
11
7
Oil
Grease
OS0642
OS0741
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.