Filter
Top Products
GB - 16
Differential Lock (924124, 126, 127,
335, 336, 337, 516, 517)
Differential Lock knob is located
on the Left Wheel Hub. With
differential locked power is
applied equally to both wheels.
To engage differential lock:
• Pull and turn knob to LOCKED
(1) position and release (knob
will snap in place when
positioned correctly).
To resume differential action for
transport:
• Pull and turn knob to UNLOCKED (2)
position and release.
Axle Lock Pin (Figure 13) (924125, 128,
338)
Use the axle lock pin to lock or unlock the right
wheel. Lock the right wheel to increase
traction; unlock the right wheel to allow for
easier turning of the unit.
Scraper Blade
The scraper blade allows the back of the
housing to keep better contact with the surface
being cleared. It also prevents damage to the
housing from normal wear.
IMPORTANT: DO NOT allow Scraper Blade to
wear too far or Auger/Impeller housing will
become damaged.
Runners
The runners control the distance between the
scraper blade and the ground. Adjust runners
equally to keep blade level with the ground.
Refer to Pre-Start for recommended settings.
Drift Cutters (Figure 14)
Drift cutters break up snow drifts that are taller
than the auger housing and direct the snow
into the auger. Store the drift cutters on the
auger housing when not in use. Install them as
shown below so they are taller than the snow
to be cleared.
1
2
OL2730
Figure 13
Wheel Unlocked
Wheel Locked
Axle
Lock
Pin
1.Stored Position
2.Operating Position
1
2
Figure 14