Filter
Top Products
9 - 30
9.1 LIFT SYSTEM
Refer to Figure 29 for the lift system.
The mower pan lift system is a manual lift system
controlled by the operator.
9.2 LIFT SYSTEM REMOVAL
1. Remove the mower deck from the unit prior to lift
system removal.
2. Place the lift handle in the highest cutting height
available.
3. Remove the plate, parking brake knob and front
panel to expose the lift system.
NOTE:
The decklift handle must be in the highest posi-
tion when the tension spring is released. This places
the spring in the relaxed state.
4. Remove the tension spring.
5. Lower the decklift handle to reduce stress on the
release handle.
6. Remove springs on the release handle.
7. Inspect and replace worn parts as needed.
8. To remove lift weldment, remove two cap screws
holding bracket handle to lift weldment. Remove
cotter pins and two flat washers on each end of
weldment. Slide weldment to the left until it clears
the bushing. Lower and slide right to remove.
9. Assemble in reverse order.
SECTION 9 - LIFT SYSTEM
Figure 29
1. Tension Spring
2. Decklift Handle
3. Release
4. Detent Plate
5. Handle Bracket
6. Lift Lever
PE0450
1
2
3
4
5
6