Filter
Top Products
6 - 19
6.1 CLUTCH TO DECK DRIVE BELT
REPLACEMENT
1. Disconnect idler spring from the frame, Figure 16 .
IMPORTANT:
This requires a spring hook. DO NOT
use a side cutter pliers. The belt can be easily removed
from the deck.
2. Remove belt from electric clutch and drive pulley.
3. Install new belt onto drive pulley and electric
clutch, checking for belt clearance.
4. Connect idler spring to frame.
6.2 MOWER DECK BELT REPLACEMENT
(48" DECK)
1. Remove mower drive belt (see procedure above).
2. Detach mower deck from tractor. See to
Remove
48" Mower Deck
in
Service and Adjustments
.
3. Remove sheave covers.
4. Remove mower idler spring.
5. Remove mower deck belt.
6. Install new mower deck belt onto mower sheaves
and idler.
7. Install mower idler spring.
8. Reinstall sheave covers.
9. Reinstall mower deck to tractor. See
To Install 48"
Mower Deck
in
Service and Adjustments
.
10.Reinstall mower drive belt.
SECTION 6 - MOWER DECK
CAUTION:
Before performing any service or
adjustments:
• Turn PTO switch "OFF".
• Park mower on a hard, flat, level surface.
• Place steering control levers in neutral
lock (fully outward) position.
• Set parking brake.
• Turn ignition switch "OFF" and remove
key.
• Wait for blades and all moving parts to
stop.
• Disconnect spark plug wire(s) from spark
plug(s) and place wire(s) away from plug.
WARNING:
AVOID injury from stored energy
in lift assist spring. DO NOT unlock
attachment lift lever with mower deck
removed. ALWAYS engage attachment lift
lever lock when removing mower deck.
WARNING:
MOVING PARTS can cut or
amputate body parts. ALWAYS wait for
moving parts to stop before unit maintenance
or service.
CAUTION:
Use PROPER SPRING TOOL
when releasing and installing springs. Stored
energy in springs can cause injury.
1. Clutch to
Deck Belt
2. Clutch Idler Arm
3. Drive Pulley
4. Electric Clutch
5. Idler Spring
6. Mower Deck Belt
OT0830
Figure 16
1
2
3
4
5
6