Filter
Top Products
GB - 9
6. Connect the engine/blade control cable
to the engine.
Route the z-bend cable end into engine
shutoff lever as shown below.
Insert the cable connector into the cable
mounting bracket on the engine. Make
sure the connector snaps into place
securely.
7. Fill engine crankcase with oil. See
engine manual.
8. Set-up mower for bagging, side
discharge or mulching. See MOWER
SET-UP on page 14.
NOTE: Bagging is not standard on push
models. See ACCESSORIES on page 24 for
kit part numbers.
9. Fill fuel tank. See FILLING THE FUEL
TANK on page 13.
10. Connect the battery. See BATTERY
(electric start models) on page 21.
11. Connect spark plug wire.
12. Check the engine/blade control feature.
Try starting the engine without the
engine/blade control held against the
handlebar. Engine must not start. If
engine starts, stop engine and bring the
unit to your dealer for adjustment or
repair.
Figure 5
911110, 111
911112, 113