Filter
Top Products
GB - 12
Standard Models
To change cutting height, move cutting height
levers one notch at a time on each wheel to
set desired height (Figure 7).
NOTE: Each wheel on mower must be set at
the same height for a level cut.
OPTIONAL CONTROLS
Primer Bulb
Push the primer bulb in to add fuel for easier
engine start.
Wheel Drive Control (self-propelled
models)
NOTE: Engine must be running for wheel
drive to propel unit.
911111
To drive forward:
Slowly squeeze the wheel drive control
toward the handlebar until you reach a
comfortable ground speed. Hold the wheel
drive control against the handlebar for full
speed.
To stop:
Release wheel drive control.
Cutting Height Settings Chart
Notch Cut grass length
1 1" (25 mm)
2 1-1/4" (32 mm)
3 1-1/2" (38 mm)
4 2-1/4" (57 mm)
5 2-3/4" (70 mm)
6 3-1/2" (89 mm)
7 4" (102 mm)
High
HighLow
Figure 7
1. Cutting Height Lever
1
1
Front
Rear
Low
HighLow
CAUTION: Unit will move forward
at engine start if wheel drive
control is engaged. ALWAYS
release wheel drive control before
starting unit.
STOP GO
OM1245
GO
Figure 8